Thanks! It's OK
i am having problem in doing patch . As You have done in video at 19:50. Can you Plz help me?
@benk Dear i have closed that model .But i am facing same patch issue in another model .Hoping that you will help me. I am attaching file and picture. Plz help me.
@zaid You should zoon in very close to the connected area and make sure you selected everything. There might be a very small geometry that is not selected because it is very difficult to see if you are not zoomed in!
I did not get it for applying what i have to zoom in? Either it is patch or something else. If it is patch then it allows me to select only 1 curve. Plz guide me. Thanks
@benk i did it because i followed your tutorial. apart from that how can i fix this problem. Should i have to delete stitch ?. how can i turn my centre on?
This is a bad idea to stitch 2 overlapping surfaces. You must cut them to the edges are touching each other.
Watch my video again and watch carefully what I'm doing.
@benk i am very dissapointed now. As i followed the video again but still getting the same problem.. my centre is not on. plz help me.
Hi dear Can you plz tell me about the sketch 5 how you make it?
Hello Dude, You have done a great work. I have made the part easily upto the video and then i downloaded your attached file. Now the problem i am facing is how you make sketch no 5?
How do you add control points to the line in the middle?
i dont have this option when i wright click on the line
